Procedure
- Pull the top two mounting clips upwards to their extended position.
-
Mark mounting hole locations on the wall. Use the dimensions
shown in Figure 1,
or hold the bracket against the wall and mark the hole locations through the
mounting clips.
Note: The screw holes on the SBH can accommodate M3.5 and #6 screws.
- Drill holes in the wall based on the locations marked in step 2.
- Insert wall anchors for each hole if necessary.
-
Hold the bracket in place, insert the screws through the mounting clips and into the screw holes, and then carefully tighten all screws.
Important: Do not overtighten the mounting screws. Overtightening the screws can damage the mounting clips or bracket.Figure 1. Mounting holes, flat-mounting (left) and side-mounting (right)