Mounting a Type 1/IP20 control on DIN rail - PENN Controls - A421ABG - A421ABJ - A421AEJ - Electronic Temperature Control - A421 Standard Model

A421 Series Standard Electronic Temperature Controls with Power Cords Installation Guide

Product
Controls > Temperature Controls > A421 Standard Model
Document type
Installation Guide
Document revision
E
Revision date
2022-08-25
Part number
24-7664-3027

Procedure

  1. Provide a section of 35 mm DIN rail that is longer than the control width. Mount the DIN rail in a suitable location and use appropriate mounting hardware.
  2. Clip the control module on the rail, position the module’s upper DIN rail clips on the top rail, and gently snap the lower clips on to the bottom of the rail.