Mounting a Type 1/IP20 control on DIN rail - PENN Controls - A421ABD - A421AED - Electronic Temperature Control - A421 Series Electronic Temperature Control
A421 Series Electronic Temperature Controls with Off-Cycle Defrost Installation Guide
- Product
- Controls > Electromechanical Temperature Controls > A421 Series Electronic Temperature Control
- Document type
- Installation Guide
- Document revision
- E
- Revision date
- 2022-08-25
- Part number
- 24-7664-3035
Procedure
-
Provide a section of 35 mm DIN rail that is longer than the control width.
Mount the DIN rail in a suitable location and use appropriate mounting
hardware.
-
Clip the control module on the rail, position
the module’s upper DIN rail clips on the top rail,
and gently snap the lower clips on to the bottom
of the rail.