Preparing the DX-9100 Controller for installation and mounting - Metasys - Part No. 24-11064-00048 - DX-FAC-Adapter - Field Device - DX-FAC-Adapter
DX-ADPT-FAC4911 Installation Guide
- Product
- Accessories > Adapters > DX-FAC-Adapter
- Document type
- Installation Guide
- Document number
- Part No. 24-11064-00048
- Document revision
- A
- Revision date
- 2021-06-18
Procedure
-
Turn off power to the existing DX-9100 controller.
-
Open the lid on the face of controller.
Figure 1. DX-9100 Controller - open lid
-
Using a medium-sized flat-head screwdriver, loosen the screw on the right side
of the controller.
-
Remove the main controller section by first lifting up on the right side of the
plastic cover and then lifting the top section off completely.
Figure 2. DX-9100 Controller - remove top section of Controller
-
Leave the base section of the DX-9100 secure in place. The base
section is reused with the DX-ADPT-
FAC4911.
Figure 3. DX-9100 Controller - base section
(DX-9100-8990)