Attributes (N2 Common Outputs) - Johnson Controls - Metasys - LIT-12011147 - Software Application - Controller Configuration Tool - 13.1

Controller Tool Help

Product
Controls > Control Tools > Controller Configuration Tool
Document type
User Guide
Document number
LIT-12011147
Version
13.1
Revision date
2019-12-04

The following table describes the attributes used by this module.

Table 1. N2 Common Outputs Attributes
Name Type 1 Description Default Value
Cooling Control Status   This input is the current control status of the Flow Setpoint reset module.
  • 0=Normal
  • 1=Low
  • 2=Timing Low
  • 3=High
  • 4=Timing High
  • 5=Disabled
  • 6=Overridden
Normal
Heating Control Status   This input is the current control status of the last heating module to operate.
  • 0=Normal
  • 1=Low
  • 2=Timing Low
  • 3=High
  • 4=Timing High
  • 5=Disabled
  • 6=Overridden
Normal
Damper Control Status   This input is the current control status of the flow control module.
  • 0=Normal
  • 1=Low
  • 2=Timing Low
  • 3=High
  • 4=Timing High
  • 5=Disabled
  • 6=Overridden
Normal
Autocalibration Status   This input is the current Autocalibration status of the controller.
  • 0=Uncalibrated
  • 1=Waiting to Calibrate
  • 2=Waiting for Damper
  • 3=Autocalibrate
  • 4=Normal
Uncalibrated
Exhaust Box Control Status   This input is the current control status of the exhaust flow control module.
  • 0=Normal
  • 1=Low
  • 2=Timing Low
  • 3=High
  • 4=Timing High
  • 5=Disabled
  • 6=Overridden
Normal
Inadequate Cooling V This output indicates that the VAV box is providing the maximum cooling it is capable of. False
Inadequate Heating V This output indicates that the VAV box is providing the maximum heat it is capable of. False
Starved Box V This output indicates that the VAV box has the damper fully open and is unable to reach the flow setpoint. False
Starved Exhaust Box V This output indicates that the VAV box has the exhaust damper fully open and is unable to reach the differential flow setpoint. False
Autocal Active V

This output indicates when the VAV box controller is calibrating the velocity pressure input.

False
1 C - Configuration Mode Only, G - Default Element (Generated State, if applicable), SC - Simulation and Commissioning Modes Only, V - Calculated Value (Outputs)